Name Thomas alumina ceramic high-temperature plastic (THO4055) 
 Overview of the strains of modified epoxy adhesives, two component, room temperature fast curing, high adhesion strength, good temperature resistance, strong adhesion, superior structural performance, easy operation. 
 Scope for working under high temperature conditions, silicate, alumina series ceramic, enamel and other self-adhesive stick with each other and the surface temperature coating, bonding, filling, sealing, plugging cracks and repair. 
 Sex 

 Can 

 Special 

 Point ? Appearance: A light-colored viscous liquid component, no solid particles. Group B were mixed as light yellow viscous liquid. 
 ? Fast cure, 25 ℃, 1-3 hours early, when cure, 18 hours close to the maximum bond strength. 
 ? to 80 - 100 ℃ oven heating 45 to 60 minutes completely cured. 
 ? High bonding strength, toughness, durability, UV resistance and excellent performance. 
 ? temperature performance to meet the wide temperature range, after bonding at high temperatures is still a good bonding results. 
 ? medium viscosity glue, no bubbles, good leveling properties, good surface finish after curing. 
 ? adhesive surface is not strictly, the two groups were in proportion to deploy, easy to use. 
 ? excellent resistance to media, oil, water, acid, kerosene, alcohol, alkali, heterocyclic hydrocarbons, nuclear radiation. 
 ? Safety and toxicity characteristics: a very slight smell, no inhalation hazard, actual non-toxic after curing. 
 ? good storage stability, storage period of 18 months. 
 The main technical performance indicators are as follows: 
 Temperature range: -45 - +400 ℃ 
 Bond strength: room temperature: Tensile strength ≥ 25MPa; shear strength ≥ 22 MPa 
 150 ℃: tensile strength of 3-5 MPa 
 Use 1, will be sticky rust, dirt, wipe. 
 2, A, B component and mix thoroughly by 10:1.2-1.5 proportion of the full, uniform sizing. 
 3, is tuned to the glue applied to the adherend surface, close up, compaction, standing 2 to 4 hours. 
 4, if you need to be coated with ceramic surface after forming, you need to glue coating material such as the glue in the initial post-curing time, hot or cold forming. 
 Note 1, take the plastic tools must not be mixed. 
 2, the operating environment ventilation. 
 3, glue such as contact with skin, wash with soap and water can be timely. 
 4, unused plastic should be covered and placed in a cool ventilated place. 
 The copyright belongs to all of Thomas Technology 2005-2011