Product 
 Name Thomas magnet high temperature plastic (THO4058) 
 Overview of the strains of a double modified epoxy adhesives, two component, room temperature fast curing, high adhesion strength, heat resistance, excellent resistance to aging, easy to operate. 
 Apply 
 Range for the motor to work under high temperature conditions, magnetic (magnetic coil), magnet metal, ceramics, composite materials, self-adhesive and stick each other, and also applies to a variety of magnetic steel, magnet bonding, filling, sealing, plugging and restoration. 
 Sex 

 Can 

 Special 

 Point ? Appearance: A component of viscous liquid, no mechanical solid particles. Group B were mixed for the pale yellow liquid. 
 ? Fast cure, 25 ℃, 1-3 hours early, when cure, 18 hours close to the maximum bond strength. 
 ? If you need to hold at a temperature of 80-100 ℃ heating temperature was 30-60 minutes in the oven is fully cured. 
 ? High bonding strength, aging resistance, heat resistance, will not reduce the magnetic properties. 
 ? temperature performance to meet the wide temperature range, after the high temperature bonding is still a good bonding results. 
 ? adhesive surface is not strictly, the two groups were in proportion to deploy, easy to use. 
 ? excellent resistance to media, oil, water, acid, kerosene, alcohol, alkali, heterocyclic hydrocarbons, nuclear radiation. 
 ? Safety and toxicity characteristics: a very slight smell, no inhalation hazard, actual non-toxic after curing. 
 ? good storage stability, storage for one year. 
 The main technical performance indicators are as follows: temperature range: -45 - +410 ℃ 
 Bond strength: room temperature: Tensile strength ≥ 25MPa; shear strength ≥ 23 MPa 
 200 ℃: tensile strength :3-4 .5 MPa 
 Use 
 Method 1 will be sticky rust, dirt, wipe. 
 2, A, B component ratio by 10:1.2-1.5 full mix thoroughly. Also note that the coating of tools and magnets do not have the best choice with attractive material, plastic knife is the best choice. 
 3, is tuned to the glue applied to the adherend surface, close up, compaction, standing 2 to 4 hours. 
 Note 
 Items 1, can not take the plastic tool mix. 
 2, the operating environment ventilation. 
 3, glue such as contact with skin, wash with soap and water can be timely. 
 4, unused plastic should be covered and placed in a cool dry place. 
 The copyright belongs to all of Chengdu Thomas Technology 2005-2011